Ball Joint & Tie Rod End Boots / Covers
Made from the same high-quality compound as our CV and Steering rack boots the Ball Joint Covers are flexible and extremely hard-wearing.
The innovative design and shape ensure that the maximum number of ball joints are covered from only 4 sizes.
- Profitable - minimal stock investment required
- Superior stretch capabilities compared to natural and synthetic rubber boots
- Resistant to oil & grease, abrasion, grit and extremes of temperature
- Tear and impact resistant
Why replace Ball Joint or Tie Rod End dust boots?
Whilst some spare part distributors/suppliers would always advise the replacement of the full ball joint, if the cover is simply split or perished, in a lot of instances joint replacement isn’t either necessary or cost effective.
Replacing the cover is a simple job especially when using the Easifit tool.
Replacing the cover, instead of the full ball joint or tie/track rod end, means there is no need to check or adjusted the steering geometry saving both time and money.
Perished boot needing replacing
Ball Joint & Tie Rod Boots (Mixed 8 Pack)
2 of each size of Ball Joint Dust Cover and 'O' rings, plus the Easifit installation toolPack contents:
2x #B1 Small dust cover
2x #B2 Medium dust cover
2x #B3 Large dust cover
2x #B4 X-Large dust cover
1x Easyfit tool
Ball Joint & Tie Rod Boots (Mixed 40 Pack)
10 of each size of Ball Joint Dust Cover and 'O' rings, plus the Easifit installation toolPack contents:
10x #B1 Small dust cover
10x #B2 Medium dust cover
10x #B3 Large dust cover
10x #B4 X-Large dust cover
1x Easyfit tool
Click image for size drawing
STRETCHY Ball Joint & Tie Rod Boots
(Small #B1)
Universal Ball Joint & Tie Rod End Dust CoverFits Ball joints measuring:
Shaft: ø9-14mm
Ball: ø23-32mm
Length: 24mm
Click image for size drawing
STRETCHY Ball Joint & Tie Rod Boots
(Medium #B3)
Universal Ball Joint & Tie Rod End Dust CoverFits Ball joints measuring:
Shaft: ø9-14mm
Ball: ø28-40mm
Length: 26mm
Click image for size drawing
STRETCHY Ball Joint & Tie Rod Boots
(Large #B2)
Universal Ball Joint & Tie Rod End Dust CoverFits Ball joints measuring:
Shaft: ø11-17mm
Ball: ø35-47mm
Length: 30mm
Click image for size drawing
STRETCHY Ball Joint & Tie Rod Boots
(X-Large B4)
Universal Ball Joint & Tie Rod End Dust CoverFits Ball joints measuring:
Shaft: ø17-24mm
Ball: ø39-52mm
Length: 37mm
